Debugger commands The Debugger supports a set of command-line commands. break Sets a breakpoint at the specified line or function. backtrace Prints a summary of how your program reached the current state. clear Clear breakpoint at the specified line or function. continue Continues the execution of the program after a breakpoint. define Specifies a user-defined sequence of commands. delete Removes breakpoints specified in a debugger session. disable Disables the specified breakpoint. display Displays the specified expression's value each time the program stops. down Selects and prints the function called by the current function, or the function specified by the frame number in the call stack. enable Enables breakpoints that have previously been disabled. file Specifies the name of the program being debugged. finish Instructs the program to continue running until just after the function in the selected stack frame returns, and then stop. help Provides information about debugger commands. info Describes the current state of the program. list Prints source code lines of the program being executed. next Continues running the program by executing the next source line in the current stack frame, and then stops. output Prints only the value of the specified expression, suppressing any other output. print Displays the current value of the specified expression. quit Terminates the debugger session. run Starts the program executing until a breakpoint is reached or the program terminates normally. set Allows you to set the value of specific variables for the duration of the debugger session. source Executes a file of debugger commands. signal Sends an INTERRUPT or QUIT signal to the program. step Continues running the program by executing the next line of source code, and then stops. until up Selects and prints the function that called this one. watch Sets a watch point for an expression which stops execution of your program whenever the value of the expression changes. where Alias for backtrace command. Unsupported commands Some debugger commands are not supported in Genero Studio.