WORDWRAP

Splits a character string to match a given margin limit.

Syntax

WORDWRAP [ RIGHT MARGIN position ]
  1. position defines the temporary right margin, as a number of characters, counting from the left.

Usage

The WORDWRAP operator automatically wraps successive segments of long character strings onto successive lines of report output. Any string value that is too long to fit between the current position and the right margin is divided into segments and displayed between temporary margins:

Specify WORDWRAP RIGHT MARGIN integer to set a temporary right margin as a number of characters, counting from the left edge of the page. This value cannot be smaller than the current character position or greater than right margin defined for the report. The current character position becomes the temporary left margin. These temporary values override the specified or default left and right margins of the report.

After the PRINT statement has executed, any explicit or default margins defined in the RIGHT MARGIN clause of the OUTPUT section or START REPORT instruction are restored.

The following PRINT statement specifies a temporary left margin in column 10 and a temporary right margin in column 70 to display the character string that is stored in the variable called mynovel:
  PRINT COLUMN 10, mynovel WORDWRAP RIGHT MARGIN 70

The data string can include printable ASCII characters. It can also include the TAB (ASCII 9), LINEFEED (ASCII 10), and ENTER (ASCII 13) characters to partition the string into words that consist of substrings of other printable characters. Other non-printable characters might cause runtime errors. If the data string cannot fit between the margins of the current line, the report engine breaks the line at a word division, and pads the line with blanks at the right.

From left to right, the report engine expands any TAB character to enough blank spaces to reach the next tab stop. By default, tab stops are in every eighth column, beginning at the left-hand edge of the page. If the next tab stop or a string of blank characters extends beyond the right margin, the report engine takes these actions:

  1. Prints blank characters only to the right margin.
  2. Discards any remaining blanks from the blank string or tab.
  3. Starts a new line at the temporary left margin.
  4. Processes the next word.

The report engine starts a new line when a word plus the next blank space cannot fit on the current line. If all words are separated by a single space, this action creates an even left margin. The following rules are applied (in descending order of precedence) to the portion of the data string within the right margin:

The report engine maintains page discipline under the WORDWRAP option. If the string is too long for the current page, the report engine executes the statements in any page trailer and header control blocks before continuing output onto a new page.

For Japanese locales, a suitable break can also be made between the Japanese characters. However, certain characters must not begin a new line, and some characters must not end a line. This convention creates the need for KINSOKU processing, whose purpose is to format the line properly, without any prohibited word at the beginning or ending of a line.

Reports use the wrap-down method for WORDWRAP and KINSOKU processing. The wrap-down method forces down to the next line characters that are prohibited from ending a line. A character that precedes another that is prohibited from beginning a line can also wrap down to the next line. Characters that are prohibited from beginning or ending a line must be listed in the locale. The runtime system tests for prohibited characters at the beginning and ending of a line, testing the first and last visible characters. The KINSOKU processing only happens once for each line. That is, no further KINSOKU processing occurs, even if prohibited characters are still on the same line after the first KINSOKU processing.